KEG-WASHING
MACHINE Application: Material: Construction:
Mounted on the base frame you find: TECHNICAL DATA:
Usable for washing, disinfecting with steam and pre-pressurisation with CO² of
all types of KEGs (DIN, EURO, SCHLANK-Keg, ECO-Keg, etc.), equipped with flat,
combi or Sankey-type fittings.
The capacity of the KEG-washer is depending on the degree of soilage - approx.
10 KEGs per hour.
The KEG-washer is built completely in stainless steel, with EPDM seals; the
KEG-holding device is made in a special plastic.
- 2 washing solution tanks (1 for hot caustic soda, 1 for an acid disinfectant)
- 2 stainless steel pumps
- the KEG holding device with the washing head
- the piping with the manually operated butterfly valves.
The electronic control panel (including the thermostat, probe for protection
of the heating pole against overheating, “KEG-ready-probe”, pump
dry-run-protection) is located in the separate box.
Power Requirement:
10 A; 220 V
Water Requirement:
Min. 1/2”; 3 bar
Warm or cold water supply
Floor drain for waste water
Measurement
(in mm):
1000 mm
x 700 mm x 1300 mm